Slab Foundation Repair in Burleson, TX
Slab foundation repair in Burleson, TX. Fix settling concrete slabs on expansive clay with piers that reach stable soil below the active zone.
How slab foundations move in Burleson
Most newer homes in Burleson are built on a concrete slab-on-grade foundation. The slab rests directly on the clay, so when that clay swells and shrinks, the slab has to move with it. Because the moisture change is rarely even across the whole footprint, one part of the slab may lift while another settles, and that difference is what cracks walls and jams doors.
Watch for diagonal cracks running from the corners of doors and windows, cracks in exterior brick that step along the mortar joints, and gaps where the ceiling meets an interior wall. Inside, you may notice a floor that feels sloped, tile or grout lines that have cracked in a line, or a slab crack visible in the garage. Plumbing under a slab can also leak when the concrete moves, adding water that makes the clay behave even more unpredictably.
Slab repair does not chase every hairline crack. The goal is to support the low areas and stop the differential movement so the structure sits stable and the interior stops tearing itself apart.
The slab repair process
Slab repair relies on piers installed at the perimeter and, where needed, under interior loads.
-
Diagnosis and elevation mapping
An elevation survey shows how far each part of the slab has moved. We identify whether the trouble is settlement, heave, or a plumbing leak feeding the clay.
-
Pier placement plan
We mark support points along the affected areas, spacing them to carry the load and lift the low sections evenly.
-
Installing piers
Piers are driven down through the active clay to firm bearing soil. The weight of the slab is transferred onto them so seasonal moisture no longer controls its elevation.
-
Controlled lift
Hydraulic jacks raise the settled sections in stages while crews monitor cracks and doors, recovering as much elevation as the slab will safely allow.
-
Restore and finish
Excavations are backfilled and compacted, and disturbed concrete or landscaping is patched. We then address the drainage that contributed to the movement.
Keeping a repaired slab stable
A slab repair only lasts if the soil around it stops swinging so hard between wet and dry. In Burleson's climate, that means paying attention to the whole moisture story: gutters, grading, flower beds against the house, and how you water during a drought. A slab that stays evenly moist moves far less than one that bakes dry on one side and floods on the other.
This is why we treat drainage correction as part of slab work rather than a separate concern. Water that collects against one edge of the foundation keeps that clay swollen while the opposite side dries and drops, which is a recipe for repeated cracking. Getting water to move away from the slab evens out the pressure underneath.
If your symptoms are still mild, start with a foundation inspection so you know exactly what is happening before choosing repair. And if you are weighing whether your home is slab or pier-and-beam, our foundation repair overview explains how the two approaches differ.
Frequently asked questions
What causes a concrete slab to crack in Burleson?
The main cause is expansive clay that swells with moisture and shrinks in drought, moving different parts of the slab by different amounts. Plumbing leaks under the slab and poor drainage make the movement worse.
Can every slab crack be closed by lifting?
Many cracks close or tighten as the slab returns toward level, but some remain visible and are patched cosmetically. The priority is stopping the differential movement, not making every hairline disappear.
Do you check for plumbing leaks?
When symptoms suggest water is feeding the clay, a plumbing leak under the slab should be ruled out, because repairing the foundation without fixing the leak lets the movement continue.
How disruptive is slab repair to my home?
Perimeter piers are installed from outside, so interior disruption is limited. Interior support points require accessing the slab through the floor, which is patched afterward. We explain what to expect for your specific plan.
Talk to someone about your job
Call to describe the problem and get a quote for work in Burleson, TX.